Polar CS200 Uživatelský manuál stáhnout pdf (Strana 13)

16 – ENGLISH

5. Fine-tune the positioning of both the crank magnet

and the sensor so that the magnet passes close

to the sensor without actually touching it.

The maximum distance between the cadence sensor and

the crank magnet should be 4 mm/0’16”. The gap is correct

when you can ﬁ t a cable tie just about between the magnet

and the sensor. It is important that the lower corner of the

sensor must face the magnet when rotating, also when the

sensor has been attached to the seat tube. The lower corner

of the sensor is shown with an arrow in the picture. Once

the crank magnet and the sensor are positioned correctly,

tighten the cable ties securely and cut off any excess cable

tie ends.

max 4 mm /

0’16’’

Before you start cycling, you should set the wheel size of

your bicycle into the cycling computer and turn the cadence

function on. For further information see pages 45-48.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 66 67

Žádné komentáře

Polar CS200 Uživatelský manuál Strana 13